Slip and Slide No More

Anything that keeps you safer during driving is a good thing--if it's cheap and easy to use, it's that much better.


Every officer that has been in a pursuit or other precision driving situation has experienced the difficulty of staying firmly planted in the driver seat when the patrol vehicle is being maneuvered through tight turns and the like. Even with a safety belt on--which should always be the case--it's pretty easy to start sliding around. That can really reduce your ability to control your vehicle, and can sometimes cause you to input inappropriate stress into the management of your steering wheel. If your body isn't firmly anchored in the seat, as you shift around, you are likely to put strain on the steering wheel just by trying to brace yourself.

This problem is made worse when your patrol unit has bench seats, or some bucket seats that don't have adequate side bolsters on each side of your hips. That describes many cars on the road, and most patrol vehicles.

Many high performance vehicles, such as racing vehicles, have custom fitted seats that assist the driver in overcoming this issue. Additionally, the same high performance vehicles are often equipped with four-point harnesses which really lock you down in the seat.

There are two problems with trying to use such a four point harness in a patrol vehicle: First--and most important--is the officer safety issue. You don't want any sort of restraint that limits you in moving your upper body. If you need to duck below the level of your dashboard quickly, you don't want a harness that keeps you from doing so. Secondly, the cost of retrofitting patrol units with such a system would be prohibitive for many departments.

So, many officers are faced with being loosely held in their seat with a standard, factory safety belt "three-point" system. That system helps, but it really could do the job better.

Center of Gravity

I've been experimenting with a simple device that helps to reduce unwanted movement while driving--the CG-Lock (CG stands for Center of Gravity). I've had one installed in my personal vehicle for the past few weeks, trying it out.

The CG-Lock is a device that clamps onto the "tongue" portion of your safety belt. Think about that talk the flight attendant gives every time you get on an airplane, "...place the flat metal end into the buckle...". The CG-Lock clamps onto the back edge of the "flat metal end" slider on your safety belt. Once you've mounted it to the trailing edge of that piece of your belt, you add a small slider piece on top of the webbing of the safety belt. This sounds confusing, and the instructions the company provides are similarly obscure, but if you go to the CG-Lock web site and watch the short installation video, it becomes ridiculously simple--it's just hard to describe.

Anyway, once it's mounted on your buckle, you just use your safety belt as you normally would. However, when you want to be snugged up in your seat, you grab the shoulder portion of the belt and pull upward, tightening the lap belt. The harder you pull, the firmer you are locked down into your seat. This keeps the lap portion of your belt tightened down, but allows your upper body to move just as freely as it normally can.

The CG-Lock manufacturer claims that the lap portion of your belt provides approximately 80% of the stability that a four-point harness would. I don't know about that exact number, but once the CG-Lock has tightened up your lap belt it absolutely keeps you firmly locked into your seat.

In order to release the CG-Lock mechanism, you flip a small lever on the side of the unit. If you want to leave the CG-Lock attached to your belt, but not use it (kind of leaving it in "standby"), you remove the small slider plate from the top, and your safety belt functions just as it normally does.

This content continues onto the next page...
  • Enhance your experience.

    Thank you for your regular readership of and visits to Officer.com. To continue viewing content on this site, please take a few moments to fill out the form below and register on this website.

    Registration is required to help ensure your access to featured content, and to maintain control of access to content that may be sensitive in nature to law enforcement.